Raspberry Pi Rack

prusaprinters

<p>I made a simple modification to the original middle section of the <a href="/yooodaha">yooodaha's</a> design. I wanted to use standard 25mm+6mm standoffs, so I recessed the holes a bit, so the standoffs could screw into the standoff below it.</p> <p>This thing is just the middle section. You can use this with the original top and bottom sections, or I just used the middle sections for all of them, as I like the increased air flow of the middle section.</p> <p>Use the<strong>cart</strong> from the <a href="https://www.thingiverse.com/thing:2795195">original design</a></p> <p>It's best to assemble this from the bottom to the top.</p> <p>I used the following hardware:</p> <p>M4 25mm + 6mm standoffs (just search for this on amazon)<br/> M4x6mm screws for the top.<br/> M3x4mm screws to attach raspberry pi to cart.<br/> M4 nuts for the bottom.</p> <h3>Print instructions</h3><h3>Category: Electronics Print Settings</h3> <p><strong>Printer Brand:</strong> Creality</p> <p><strong>Printer:</strong> Ender 3</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> .2</p> <p><strong>Infill:</strong> 25%</p>