Raspberry Pi Pico Case - Snapfit, Screwless

prusaprinters

Raspberry Pi Pico Case Compatible with theRaspberry Pi Pico Snap fit design - no screws required Quick and easy to print, no supports and minimal size Designed to use minimal filament Screwdriver slot for easy lid lifting/opening Access to the boot button using insulated paperclip (using vented lid) USB socket access Choice of lids including vented Iid for good cooling I/O header access lid Plain lid to drill your own holes for jumper wires, etc, as you require them Multiple mounting positions - other requests considered (use the comments) Ribbon cable access top All lids and bases are interchangeable Can be used with pin or socket headers, or direct solder connections Use: The lids should flex slightly under pressure to remove it from the case or insert it, it "snap fits", put one side in first then the flexi and clip the other side in. The ribbon cable lid has "gull wings" that need to be bent along the V seam, up by 45 degrees, after printing. This provides access for ribbon cables or smaller jumper wires, whilst keeping the holes minimal so avoid debris from falling into the case. The one photographed is PLA. Use a hair dryer or heat gun along the hinge seam to soften it if it is a problem to fold. If using metal screws/bolts with base mount, please place insulation tape over screw heads for peace of mind. Although the holes are countersunk, its best to be careful. Version History 05 April 2021 - Added V1 with vented lid and IO port access 12 April 2021 - Made lug larger on lids for firmer fit 13 April 2021 - Created Versions with Side, Internal (base) and end mounts Printing advice I recommend printing with a good level of infill40%+ to allow good strength with the sides. Also recommend part cooling fan to print good quality posts and sharp detail. Designed to not require supports, print all parts flat on the bed. Use different filament for lid and box for visual impact. Tweaks to design will be considered, please comment. Print Settings Printer Brand: Creality Printer: CR-10S Resolution: 200 Infill: 35 Filament: none PLA Notes: A good clean print is required for best fitting. Try to avoid squish on first layer for a good lid fit. Category: Electronics