Raspberry Pi Official 7 Inch LCD Mount/Bracket for 2020 Extrusions REMIX

thingiverse

This is a remix from the idea by jterranella, and I'm really impressed by it. I needed to create a bit of an angle (about 10°) to prevent the Pi and Case from colliding with the PSU on my Kossel Linear Plus. Additionally, I added some chamfers and rounded corners just to satisfy my obsessive-compulsive disorder. I attached the bracket to the extrusion using 5x12mm screws and t-nuts. The LCD was secured to the bracket using 3x12mm screws. Don't worry; the LCD is only mounted on an Ender 3 to demonstrate how it works - it's not permanently installed there. It's actually part of my Kossel Linear Plus setup. If you appreciate this project, please give me a "like"! Your support means a lot to me. If you'd like to show your appreciation with a small gift, consider donating through PayPal.