Raspberry Pi Noctua 40mm fan mount Remix

thingiverse

This is a remix of the Raspberry Pi Noctua 40mm fan mount by ExplainingComputers. All credits go to him. I reinforced the base section up to 5mm in height, added holes to the corners because I'm mounting the Raspberry to the wall and widened the gpio gap by 1mm. I added a gap for better access to the sd card slot and some 5mm spacers onboard. For wallmounting the case, I use some 10mm spacers which you will find included. I am using 4 x M2.5 15mm screws with no nuts to fasten the top and the base parts together. To fasten the fan, I'm using double sided duct tape, but 4 x M3 12mm bolts and 4 x M3 nuts might do the job as well. For mounting the case to the wall, I am using 4 x 5mm by 40mm screws. Designed with FreeCAD 0.17. All part files are included.