Raspberry PI NAS Case for dual 2.5 inch SSDs

thingiverse

# Introduction Yet another lightweight, small form factor and open NAS case for the Raspberry Pi. This design was inspired by Szmalus' excellent design: https://www.thingiverse.com/thing:3850735 However, it didnt feature a fan mount and the SSDs were needed as a structural element of the case. Since I often need to swap SSDs and need a place to mount my fan, I designed a new case. # Compatibile with: - Raspberry PI 1B+/2B/3B/3B+/4B - 2.5 inch SSDs (7mm height) Note: The spacing between the two SSDs is 5mm. Make sure you are not using thick SATA to USB adapters! # Features: - "quick release" for drives (small nobs instead of SSD mounting screws) - optional ability to additionally secure drives with traditional mounting screws - optional 40mm x 10mm fan mount (tested with NF-A4x10) - SSDs are not required for structural integrity of the case - lightweight and easy print # Bill of Materials: - 1x Raspberry Pi 4 (duh) - 4x M2.5 x 10mm mounting screws for Raspberry Pi 4 - 4x M2.5 nuts - 4x M3 x 10mm countersunk screws - 4x M3 nuts If you also want the fan mount you additionally need: - 1x 40mmx10mm fan - 2x M3 x 10mm countersunk screws - 2x M3 nuts - 4x M5 x 10mm fan mounting screws (these usually come with the fan) # Parts to print for version WITHOUT fan - 2x brace_long_side - 2x brace_short_side - 2x column_noshift_noscrew - 1x column_shift - 1x column_shift_mirror # Parts to print for version WITH fan - 2x brace_long_side - 2x brace_short_side - 2x column_noshift_noscrew - 1x column_shift_fan - 1x column_shift_fan_mirror - 1x 40mm_fan_mount # Print settings - enable support - all parts need to be rotated to desired position in slicer - use high wall/top/bottom count with high infill to make it sturdy # Assembly Have a look at the pictures