Raspberry pi mountable case and camera pivot case

thingiverse

Barneyj made a remarkable effort with a pivot mount for the camera on the casing. The files were edited to allow the raspberry case to be either wall-mounted or ceiling-hung using screw holes. Furthermore, the ball-mount for the camera can also be installed on a surface, separated from the case. The screw holes measure 3.2mm in diameter, close to an eighth of an inch minus shrinkage. A separate file containing only the parts required for the camera's wall-ball mount was added. In edit mode, a bug emerged as some prints are meeting specifications except for one piece which is 1mm off in width alone despite the SKB file being intact. Double-checking files and re-uploading them were undertaken; an additional section was incorporated into the wall-mount part for the camera to accommodate larger openings. The updated file named "wall_part_only" has been made available as a precautionary measure in case others are experiencing similar difficulties, allowing it to be used directly while deleting the original part.