Raspberry Pi Mount for Anet A6

thingiverse

This is a custom mount designed specifically for the Raspberry Pi, which is housed in a protective case, and is intended for use with the Anet A6 printer. The mount attaches securely to the back of the operator's LCD panel on the rear of the printer. Four sturdy standoffs are positioned underneath the mount, elevating it from the panel and providing additional support. To assemble the mount, you will need four 50mm-long bolts and eight nuts. Begin by removing the original fasteners and replacing them with the new ones, followed by adding four nuts in the same configuration as before. Next, install the four standoffs and then carefully position the mount onto which the Raspberry Pi is already installed. Finally, secure everything in place using a further four nuts. Please note that you will need to drill your own holes to accommodate any case used for the Raspberry Pi, as this may vary depending on its design and mounting configuration.