Raspberry Pi Flush LCD Wall Mount

thingiverse

Wall mounted case for a Raspberry Pi and the official Raspberry Pi 7" LCD touchscreen using a dual gang low voltage mounting bracket. ###Update 11/11/2020 - Added a 3-Gang hanger per request. This piece has not been printed or tested for fit. Parts: * Any model of Raspberry Pi supported by the official Raspberry Pi 7" LCD touchscreen * Official 7" LCD Touchscreen from Raspberry Pi * POE Hat (https://www.amazon.com/LoveRPi-Power-Over-Ethernet-Raspberry-Compact-Non-Isolated/dp/B07WD7HXSQ/ref=sr_1_4?dchild=1&keywords=raspberry+pi+poe+hat&qid=1585957699&sr=8-4) * Dual Gang Low Voltage Mounting Bracket (https://www.amazon.com/iMBAPrice-2-Gang-Voltage-Mounting-Bracket/dp/B00HFEFZRC/ref=sr_1_3?dchild=1&keywords=dual+gang+low+voltage&qid=1585957949&sr=8-3) * 4 M3x4mm screws to mount the case to the LCD * 2 X 6-32 screws to hold hanger onto mounting bracket It is recommended to use a POE hat as it's not safe or legal to bury an extension cable in the wall. Note that I don't have a POE hat on mine in the photos as this was for testing purposes only. In order for the ethernet port to clear the sheetrock in a standard wall, you will need to increase the standoff of the Raspberry Pi from the LCD controller. A quick easy way to accomplish this is to remove two diagonal standoffs and stack them on the other two. This seems to be plenty stable since there won't be any stress on the board inside the wall. You could also purchase additional standoffs and use those on top of the four original ones. This design mounts the LCD upside down and will require you to add the following line of code to your /boot/config.txt file: lcd_rotate=2