Raspberry Pi Drawer for Creality Ender 3 V2

thingiverse

This is a Remix of the Pi Drawer by Syntax. For my project I wanted to power the Pi off the Printers 24V power supply so I have made room for a buck converter to also fit in here. The drawer is slightly loose in the box as pointed out by KollegeMostrich in the original make but this is very minor and I haven't found it to effect the outcome. A 8mm hole was drilled in the bottom of the box for cable to be fed through and into the rear left hole of the drawer for power I have also added a few cable tie downs to help with cable management. Handle hole has been provisioned but I haven't bothered to make one yet. Fan cables also needed extending. Parts needed: 1x Raspberry Pi Model 3B+ 1x Buck Converter w/ display ([DFR0379](https://core-electronics.com.au/20w-adjustable-dc-dc-buck-converter-with-digital-display.html)) 1x 30mm fan (I used [HighPi Pro 5V Cooling Fan](https://core-electronics.com.au/highpi-pro-5v-cooling-fan.html)) 8x M2x12 bolts w/ nuts (For mounting hardware) Micro USB Cable (I used this from [StarTech](https://www.startech.com/en-au/cables/usb2aub2ra1m)) - However the shortest option was 1m so I cut out a length in the middle to shorten and resoldered. But was the only cable I could find which had both ends angled in the correct directions Printed with a 5mm brim and supports for all holes except the cable tie down points. Supports here would be difficult to remove and create a high risk of breaking the tie downs.