Raspberry Pi Corner low profile Camera Mount for Mecreator 2

thingiverse

I recently installed an Octoprint server, eager to unlock one of its best features: a Pi camera. My Pi Camera Version 1.3 was ready for prime time. In search of the perfect camera mount, I stumbled upon Philipp Schmitt's design on Thingiverse (https://www.thingiverse.com/thing:2756726). The clever design seamlessly integrated into my closed Mecreator2. I printed it via Octoprint, marking a triumphant first print on the platform. Following the instructions, I encountered the same issue as Ben Fisher (Benfish65): a significant loss of build volume. Disappointment set in. The next day, I reassessed the problem and pinpointed its source: the design's idea was great, but it needed to be more compact and positioned lower to preserve the full build volume. I rewrote the specifications to better suit my needs: - The build volume should remain intact - The design must be as compact as possible - It should have minimal tilt - It should fit snugly to prevent excessive wobbling - Easy installation and removal are essential Armed with these new requirements, I dove headfirst into Fusion 360. During the modeling process, I experimented with the mirroring function, which proved to be an exciting learning experience. The result exceeded my expectations: * The build volume remains unchanged, with the holder mounted 1 or 2mm below the carriage level * Compactness is achieved through a mere 2-degree tilt * Four 12mm magnets secure it in place and facilitate easy installation and removal * A rounded back corner adds a touch of finesse Despite initial bed levelling issues, the printed object turned out correctly. Everything went smoothly from start to finish. The final product exceeded my expectations, seamlessly integrating alongside my panels hooks without any issues. The view may not be as dramatic as a 45-degree angle, but it provides an accurate and sufficient perspective for monitoring prints.