Raspberry Pi case for Hive Interface Board

thingiverse

This is a Raspberry Pi case designed specifically for the HiveTool Hive Interface Board Version 0.2 & Version 0.3. Make sure to print the correct version so that the RJ14 jacks are labeled correctly. When soldering the board, leave the LED leads long enough for them to come up through the hole in the top. To compile the SCAD files, place the required STL from the original "Raspberry Pi 3, Pi 2, and Model B+ case with VESA mounts" (thanks for your work) in the same folder as the scad file. You can find this STL at https://www.thingiverse.com/thing:922740. I modified the design to remove the elliptical cutouts from the bottom of the case. I also added knockouts for spare GPIO's, camera, etc... and included text to identify the RJ14's and polarity. This version is marked as 0.3. The edges of the knockouts are rounded and smoothed out even further, and the top of the original design was cut out a bit more to improve clearance. I also added some feet for the load cells. Print this case out using PETG. To assemble it, run a bolt up through the bottom and attach a washer and nut on the top before screwing it into the load cell. I included a schematic for an oxalic acid vaporizer timer that I use. You can find the parts I used at https://www.ebay.com/itm/CN101-Digital-LCD-Power-Programmable-Timer-Counter-Time-Relay-Switch-DC-12V-16A/182042164800?epid=858341801&hash=item2a628efe40:g:Up0AAOSw63FaN2xD and https://www.ebay.com/itm/Car-Auto-DC12V-Volt-30-40A-Automotive-4-Pin-4-Wire-Relay-Socket-30amp-40amp-EP/222815530173?rt=nc&_trkparms=aid%3D222007%26algo%3DSIM.MBE%26ao%3D2%26asc%3D44040%26meid%3D0e7e662cce36440fa873c302656d57ca%26pid%3D100005%26rk%3D1%26rkt%3D6%26sd%3D271551630408%26itm%3D222815530173&_trksid=p2047675.c100005.m1851. I also designed an enclosure for the Temp/Humidity sensor, which you can find at https://www.thingiverse.com/thing:2913641.