Raspberry Pi case adapter for Prusa MK2

thingiverse

I've been using the original version of the Hofftari Octoprint case with my Prusa i3 MK2. It's an earlier design that fits flush against the back of the printer, rather than at a 90-degree angle. I recently upgraded my print head with new parts from the MK2S upgrade kit, but they were too close for the original version, so I didn't want to reprint the entire case just to fix it. Therefore, I created this adapter to hold the original case at a 90-degree angle. It requires an additional two M3 6mm screws to attach the case to the adapter, but it works perfectly with my setup. Since I didn't upgrade the Rambo case, I'm not sure if this would work with a full MK2S upgrade. The Octoprint case now sits lower than in its original position.