Raspberry Pi camera mount for duplicator i3

thingiverse

This is a camera mount for attaching a Raspberry Pi camera board onto a Duplicator i3 v2.1. The Point-of-View (POV) follows the Z-axis, providing a great overview of your print from bottom to top. One version, number 39, can be attached to the left side of the X-gantry without obstructing anything. However, this will reduce the width of the X-axis if attached on the right. If you prefer to attach it on the right, like I do, you should print version #49. This version is longer and provides a better view, as shown in the two pictures that demonstrate the POV. The downside of this version is that it's relatively flimsy and prone to vibrations. To install the camera mount, you'll need 4 or 2 pieces of M3x10 screws, depending on which version you choose. The original screws will be too short for this purpose.