Raspberry Pi Camera Mount for CR-10

thingiverse

UPDATE: Added center mount arm, remixed from https://www.thingiverse.com/thing:2585996 by Fuganater. It's probably more than is needed for the Pi camera, but it provides extremely stable results and produces much better time lapse outcomes than the corner mount. This file may require supports, I printed without supports and got sagging on one of the arms. This is a mashup of 3 things to create an optimized bed mount for the Creality CR-10 and Raspberry Pi Camera v2. Time-lapse videos are greatly improved by mounting the camera to the print bed on a moving Y-axis. I thank the creators of the original things. mounting arm https://www.thingiverse.com/thing:2594210 by jimmysinkers camera front https://www.thingiverse.com/thing:403712 by anoved camera back https://www.thingiverse.com/thing:247590 by 3dkarma The camera front and back were used unaltered. The mounting arm was modified in Sketchup and TinkerCAD to mount the camera case with a M3 screw and enable sideways printing. I included the upright arm for what it's worth, but the sideways arm prints significantly faster. Print settings print camera front and back and one arm, sideways (recommended) or upright 20% infill supports on mounting arm Assembly 1 M3*16 screw (16mm is a tight fit, can go up to 20mm) 1 M3 nut 2 M3 washers Drilling out the screw holes with a 3mm bit really helps with assembly. The tabs on the mounting arm can be considered fragile until the camera case is attached. Timelapse of https://www.thingiverse.com/thing:146403 print on https://youtu.be/0-8mePeVeRg