Raspberry Pi B case

thingiverse

I was searching for a casing for my outdated 256mb Pi, but there wasn't anything that precisely matched what I was seeking. So I chose to design my own case inspired by Cesear's https://www.thingiverse.com/thing:446921. The foundation has two raised areas to support the Pi and keep the board level so the ports stay aligned with the case openings. The top of the case secures the board in place by clamping the USB ports and a clamp block over the SD card. The GPIO pins are accessible after removing the small rectangular cover by clipping out the 4 tiny supports. The casing is held together with 12mm M3 screws in the four angled feet, from underneath. It relies on the screws biting into the top layer to stay stable.