Raspberry PI (B+, 2, 3) Drone case

thingiverse

I really liked http://www.thingiverse.com/thing:1637932 because it didn't look like a Raspberry Pi B+, 2B, or 3 case.\nAs I'm very fond of drones, I decided to create a Raspberry Pi case that resembles one.\nThe result is what you see now,\nbecause I built my drone around this design without reinventing the wheel.\nI really like the way it turned out, because it's unique.\nBTW: Use OpenScad 2016.10.04 if you want to edit this thing successfully.\nPrint Settings\nPrinter:\n Hesine\n \nThe raft settings are as follows: No rafts at all,\nbecause I didn't need them.\nSupports are necessary, so they're included.\nThe resolution is set to .4 nozzle with .1 layers,\nbecause that's what works best for me.\nThe infill percentage is 20%, because it's just right.\nNotes:\n I printed the top at 99.6%\nin order to make sure it fit perfectly,\nbecause I didn't leave room between the bottom and the top in the design.\nPrinting it a little smaller was enough, so now it fits just fine.