Raspberry Pi and 5 Inch Display Case

prusaprinters

<p>A case for a Raspberry Pi with a 5 inch display.</p> <p>I made this to be used with Octoprint...</p> <p>The display and Raspberry Pi just sit in the case and are held in place by the front cover, no screws.</p> <p>Front cover clips into place by placing the bottom in first and then pushing in the sides and top.</p> <p>There are air vents on the top and bottom at the front to allow air to flow up through the case.</p> <p>This is the display that the case is made for: LANDZO 5 Inch Touch Display <a href="https://www.amazon.com.au/dp/B07VFFBDY5/ref=cm_sw_em_r_mt_dp_ERDXN0MVPC33S29QK7J8">https://www.amazon.com.au/dp/B07VFFBDY5/ref=cm_sw_em_r_mt_dp_ERDXN0MVPC33S29QK7J8</a></p> <p>I made this design quite a while ago, it's not perfect, but it works well enough for me. The way the front clips on could probably be improved.</p> <p>Designed in Fusion 360</p> <h3>Print instructions</h3><p>I think I originally printed this using a 0.2mm layer height in PETG.</p> <p>I think if I printed it again I would try a 0.3mm layer height to make it a bit quicker.</p> <p>I used PETG because in the past I have had issues with clips snapping in PLA.</p> <p>Make sure you place the front cover down flat on the build plate.</p> <p>Print without support.</p>