Raspberry Pi 7 Inch Screen Minimal Rollbar Case - Easy Print - No Support

thingiverse

7/26/2019: Final Version here --> https://www.thingiverse.com/thing:3771857 - Bigger handles offer better access for cables, protection for the Pi board, and an optional fan mount. This design is a more minimalist take on my rollbar case for Raspberry Pi 7 inch touchscreen. The original version remains largely unchanged; it's simply been divided into thirds with the middle section removed. It takes approximately six hours to print both parts. Printing works best when done on its side, allowing the handle to lie flat. No supports are needed, and even complex bridging poses no problem. Clearance around the screen's power ports is also not an issue. This design can be considered the better version. I printed using four shells, six top layers, and zero percent infill. With this setup, there's minimal top surface to close up with additional top layers when printing on its side.