Raspberry Pi 4 Touchscreen Case & Holder

thingiverse

This remix of Ender 3 Touchscreen Case & Holder for Raspberry Pi by Tronnic required modifications to accommodate a Pi 4. The case needed to be enlarged to fit the larger board, so I increased the video ribbon cable slot on the side to allow my camera ribbon cable to exit there as well. To provide additional stability, I thickened the top rim by 1mm because it was too thin for my liking. Update 1.1: I created a new case with the lettering removed at TallDonkeys' request and also remixed the rear fan cover piece. The original design had a loose fit on my setup, so I extended the stands about 1mm to secure it more snugly. If 1mm is still too much, you can always sand it down to fit your build perfectly.