Raspberry Pi 4 - Simple Bumper

prusaprinters

<p>This is a simple bumper case for your Raspberry Pi 3 or 4.</p><p>With the board screwed in place, the Micro SD card is protected, but you still have access to the slot. &nbsp;There are also support ledges around the outside, to stop the board from flexing if you press down on it. &nbsp;You <i>can</i> print it without supports, but the nut traps will be a bit ragged, so it's not recommended!</p><p>You'll need 4 M2.5 x 8mm screws, and 4 M2.5 nuts to secure the board. &nbsp;</p><p>Update: &nbsp;I have added a second version of the bumper with a notch cutout under the row of connector jacks as a couple of people have told me that some cables are a little tight because of the housings on the cables. &nbsp;This solves that issue.</p>