Raspberry Pi 4 + PoE Hat Case + Camera Mount for Ender 6

thingiverse

A case my Rasperry PI 4 with PoE (Power-over-Ethernet) Hat that fits nicely in the left side of my Ender 6. It also doubles as support for the camera mount. It has three parts: the main mount/holder held with the same M6 screw that comes with the printer and holds the acrylic left pane; the bottom enclosure for the Pi, which has two forks that press fit into corresponding rails in the previously mentioned holder; and the upper part of the enclosure. All in all, everything press fits and you don't need any other parts that you don't already have (the printer's left pane upper M6 screw). I did add a thin double sided tape to prevent the Pi from shaking too much. The Pi enclosure is a remix from the one found in [Hazi's Raspberry Pi 4 Case Top + Easy Fan Mount / PoE-Hat Support](https://www.thingiverse.com/thing:3724434). I removed most of the internals as they would collide with my PoE Hat, and adjusted the fan mount a few milimeters to the left and down to precisely match my particular fan. I also added a slot for the camera's flat cable to pass through and the connector [sneak](https://www.thingiverse.com/sneaks/designs)'s camera mount system: [Articulating Raspberry Pi Camera Mount for Prusa MK3 and MK2](https://www.thingiverse.com/thing:3114849). And, of course, I added the rails to the bottom of the enclosure to fit the holder. The holder came from [Stuart800](https://www.thingiverse.com/stuart800/designs)'s from [Ender 6 Toolholder Remix](https://www.thingiverse.com/thing:4726544).