Raspberry Pi 4 Model B Retro Case for Lasercut and 3DP

thingiverse

***v2.0 Eliminates redundant cuts by correcting doubled vectors. Enlarged screw holes allow for effortless drilling without extra steps. Lowered connector holes enable secure fastening with a single nut under the PCB as a standoff. The living hinge on the STL top features expanded slits, simplifying printing. Minimal revisions were made to this design inspired by McNugget's original work. It can be produced through either laser cutting or 3D printing, or even a combination of both methods! For optimal 3D printing results, walls are set at 1.2mm thickness, and infill is applied only to the grid, achieving an airy structure. Laser cutting, on the other hand, requires 3mm acrylic material. Required hardware includes six M3-12 screws and ten nuts, with four reserved for use as standoffs under the PCB. The PI holes are slightly smaller than 3mm, necessitating a slight expansion to accommodate standard fasteners.