Raspberry Pi 4 Case w/ hanging mount for Prusa MK3/MK3s w/ 40mm fan and camera slot

prusaprinters

<p>Remix of <a href="https://www.prusaprinters.org/prints/6041-raspberry-pi-4-case-3030-hanging-mount-for-prusa-m">https://www.prusaprinters.org/prints/6041-raspberry-pi-4-case-3030-hanging-mount-for-prusa-m</a>. Moved the fan towards the edge of the case to allow an opening for the Pi camera ribbon cable right above the connector.</p> <p>Can be mounted on any side of the MK3/MK3s printer.</p> <p>I used a Noctua NF-A4x10 40x10mm fan. The fan is mounted to the case with the four screws that came in with it. To get it all to fit, I cut the fan power cable to length and added jumpers to connect it to the Pi GPIO pins.</p> <p>The Pi is held to the bottom of the case with four m3 screws. The case is held together with another four m3 screws - 18 or 20mm works.</p> <p>Like the original design, it is a bit of a tight fit when inserting the Pi into the bottom of the case but it fits with a bit of force.</p> <p>Printing flat side down with no supports.</p>