Raspberry Pi 3 ZipTie Case - Zip-Tie RPi Raspi

thingiverse

I loved the innovative design of the 0110-M-P Raspberry Pi case, but unfortunately, I didn't have all the necessary components on hand. To overcome this challenge, I created a new case that utilizes ZipTies instead. These ties are always readily available in my workshop, and the 8" ones with widths less than 3mm fit perfectly through M3 hardware holes. To simplify the design, I removed the mounting ears from the original model. However, it's easy to add them back if needed. This sleek and minimalist case fits both Raspberry Pi models 2 and 3, which was my starting point using 0110's Rpi 3 file. I also adjusted the SD card slot by a millimeter for better alignment with the card itself. This custom design retains the ribbon cable and GPIO knockout slots from the original model. I used Power Gear brand ZipTies but have seen similar ones from GB, 3M, and other brands. This new case was created using DesignSpark Mechanical, and an editable RSDOC file is included for further customization.