Raspberry Pi 3 Snap Case Vented

thingiverse

Snap case for Raspberry Pi 3 and possibly 2. Separate files are uploaded for each half. The design includes a hole for the reset switch, which is Radio Shack's 275-1547 momentary contact type. I trimmed the lugs on the switch to allow it to be soldered directly into the RUN holes on the PI board, making it especially useful for RetroPie configurations. If you don't need it, you can fill in the hole. This snap case was successfully printed at 200 microns. Smaller layers might have resulted in a more accurate fit. The photos show the design before some minor tweaks were made. I added better access to the SD card and made the switch hole smaller. I also added more clearance for the snaps to help them seat without trimming. This design was created with Tinkercad, where you can edit it online at https://www.tinkercad.com/things/kthDENxuOlH Print Settings: Printer Brand: 3D Systems Printer: Cube 3 Rafts: Yes Supports: Yes Resolution: 200 micron Infill: Honeycomb