Raspberry Pi 3 B+ Case Bear Upgrade (Octoprint/Pi logo & M3 screws)

thingiverse

I combined 3 designs into 1 The design includes extended front slot for Pi camera *not required* Modifications made to original designs: Hollowed out case holes to accommodate M3 screws Resized Octoprint and Pi logos to fit on front of case I used: 4x M3x20 screws 4x M3 nuts 2x M5x8 screws 2x M5 slot nuts After printing I found that the M3 screws I was using did not counter sync in the top of the case. Using a 1/4" bit, I had to drill the top holes a few extra mm wide to counter sync the M3 screws. You could also use longer M3 screws. Different screw brands may yield different results.