Raspberry Pi 3 B/B+ & 4B case with OctoPrint Logo

thingiverse

8/17 Update: Received my Raspi 4B and mounted it in a sturdy RASPI_4B OctoPrint Case. The design changes ensure the case fits the Raspberry PI 4B perfectly. Removed the WIP status. 8/14 Update: Fixed assembly screw hole supports with precision engineering. 8/13 Update: Due to an unfortunate incident, I deleted the previous 4B case STLs and replaced them with updated versions. **The 4B files are still a WORK-IN-PROGRESS** #DO NOT PRINT the previous files. There is a flaw in the design that puts pressure on the chip located alongside the Ethernet port and behind the adjacent USB port. The user thejustinwalsh broke his Raspi 4B pressing the case together. See his comments. Changes: - Chamfered the offending protrusion to allow clearance between the case and the chip. - Enlarged the openings for the USB-C and HDMI ports with improved accuracy. - Reduced the assembly screw size to M2.5 for a secure fit. I have also included step files for the 4B case and changed the status of the entire posting to a work-in-progress. ----- 7/20 Update: Thanks to feedback from Krrazy, a weakness in the posts was identified, and it was discovered that not all Raspberry Pi's can accept M3 mounting screws. I have updated the files accordingly: - The Pi3B/B+ case front posts have been reinforced for added strength. - There are now two versions: one using M3 screws and nuts and another using M2.5 screws and nuts. File names that end in 2,5MM are for M2.5 screws and nuts. File names ending in 3,0MM are for M3 screws and nuts. The Raspberry 4B files have not been updated as yet. 7/3 Update: (The Raspi4B files should be considered a work in progress) - Had to replace the Raspi4B files with Version 2 files. I didn't realize that when the Raspberry Pi Foundation says "drop in replacement," it doesn't mean the USB ports and Ethernet ports got switched around. 6/29 Update: (The Raspi4B files should be considered a work in progress) - Added cases for the Raspberry 4B based on CAD files downloaded from GrabCad. I don't have a 4B to test with; these are based on CAD files downloaded from GrabCad. Please leave feedback if they need adjustment or if they fit okay. All files start with Raspi4B - Found that the rear case without ears was mismatched to the case front. Updated the files to match the case front. Updates: - Case Rear - The centering ribs on "Case_Rear_with_Ears" interferes with the tightening of the hammerhead nuts. I remixed the ribs to remove the interference. - I created a thin membrane to allow the LED status indicators to show through the plastic. (As long as it's not printed in dark opaque filament.) Case_Rear V3.stl, Case_Rear_with_Ears V2.stl - Case front - Increased the width and depth of the separation between the logo and cooling slots. This is to make the logo stand out better and to make the printing easier. (Too much smoosh on first layer closed up the gap. This should be better.) Case Front v4.stl This is a remix of Licantrop's Raspberry Pi 3 B Case Bear Upgrade. The remix includes these additions: - **Case cover with OctoPrint Logo** - Access to GPIO pins - Enlarged case screws from 2.5mm to 3mm Original design features: - Access to camera ribbon cable connector - Access to SD card - MicroUSB power connector access - HDMI port access - Access to 3.5mm composite video/audio connector - LAN port access - USB port access ***OctoPrint and the OctoPrint logo are registered trademarks*** [octoprint.org](http://www.octoprint.org)