Raspberry Pi 2, 3 square round case (enclosure)

thingiverse

This is my rendering of a raspberry pi case for Pi 2&3. The case has been designed specifically to accommodate an NRF24L01 - MySensors gateway with MQTT capability. A round hole at the back allows for a threaded 5.5/2.1 female power jack, similar in design to this one: http://www.fittcon.com/socket-connector-c-7/dc-power-jack-socket-threaded-female-connector-21mmx55mm-p-20.html. Two holes on the front of the case are reserved for LED lights, including a power indicator and an NRF24 radio activity light. Update: After printing, several issues were discovered that needed attention. One of the case screw posts was slightly elevated, causing the lid not to lie flat (this has since been corrected). The mounting pegs were also found to be too low, positioning the pi at an improper height (this issue has also been rectified).