Raspberry Pi 1U Rack Mount and OLED tray (Remix)

thingiverse

This is a remake of russross' remake. I determined that in the 2 rod 1U design, the side components offered very little additional stability and prolonged print time as well as support material. After removing them and increasing the 45 degree angle of the "feet," it can be printed upright with no supports and relatively short bridges at the top. Download the original "tray" and "ears" from the original remake. https://www.thingiverse.com/thing:4125055/files EDIT: I added a remixed tray that incorporates a tiny OLED display in front. If you want a "plug in" mount for the OLED for use with the original tray, you can find it here along with the tutorial on how to set up the display. Note: Since using the official PoE Hat blocks the necessary GPIO pins, I used a breakout board cut into thirds that allows me to solder jumpers without interfering with the hat itself. This works well with my rack mount remake with the sides removed, allowing extra space to the left and right of the Pi.