Raspberry Camera Lisiparoi Mount

thingiverse

I loved the design of https://www.thingiverse.com/thing:2113975 but wanted to add some extra light to my prints using a Lisiparoi LED ring. So I redesigned the camera case. You can use it directly on thing 2113975 or remove the three arms and connect your own adapter. Printing with 0.2mm layer height is definitely possible. UPDATE: In certain settings, the space for the connector to the Lisiparoi proved too small. When combined with vibrations during a print, the back would fall off. To fix this, I made V2 with a bit more space for the connector and a higher rim on the back to make more contact with the front. After two tweaks of testing, it didn't fall off. FREE BONUS! I've added a cable clip to keep the camera and Lisiparoi cable together. Before use, bend the clip along the two thin parts, then squeeze the bends hard. Insert the Lisiparoi cable followed by the camera cable. Bend over the part with the hole, then the part with the cylinder, and finally push the cylinder into the hole and squeeze it tight. A layer height of 0.1mm is advised. The Lisiparoi also comes in an infrared design for use with the Raspberry Pi NOIR camera. The infrared LEDs will get hotter than the visible ones, but after a few hours, the case doesn't get hotter than 40-50 °C, which seems okay. More information about the Lisiparoi can be found here: http://www.lisiparoi.com. If you want to design your own case for the Lisiparoi, my model can serve as a designing aid: https://grabcad.com/library/lisiparoi-v1-0-1. Maarten_Boz has created a GoPro Adapter that you can find here: https://www.thingiverse.com/thing:4229329.