Raspberry 7 inch TouchScreen Case with Stand

thingiverse

Hi all, This new design has addressed three key issues that I wasn't satisfied with: * The SD Hatch: Removing the SD card was a major problem. The new port makes it a whole lot easier. * RPI leds: The previous case hid the RPI LEDs completely. There's now a viewing portal to allow for clear visibility. * Stand/Mount: There is now a GoPro-style mount that allows easy adjustment of the viewing angle. It's fully compatible with any GoPro mount you might have. In addition to what came before, you'll need: * 1 M3x3.5cm screw for the mount. Just screw it in until it reaches the end - don't overdo it. * 1 M3x5.5mm square nut that gets inserted on top of the stand and where the mount screws in. ATTENTION: This case is a much tighter fit than the previous one. Be sure to remove the SD card before installation, and try to move the ribbon cable out of the way by shifting it to the left side facing upwards. Enjoy!