Ramps Case with Full Graphic Smart Controller and 60mm Fan

thingiverse

UPDATE: added files for use without a display or external display. Two new files designed to accommodate an 80x80mm fan. :)\nNew clips available for mendelmax and tmax frame, updated with latest design. Latest clips only work with the most recent case files.\noptimized part "lid-fan-display.stl", uploaded again. Now includes a clip to secure the display cable in place and a fan guard for protection against accidental touch... ;)\nCase_V3_backhole.stl:\ncase featuring a cable hole on the air guide side and closed at the bottom. One of the bottom holes should be partially closed with 2-3 layers, easily removable if needed.\nThis is an ongoing "Under Construction" remix of a case originally designed for Rumba.\nFull Graphic Smart Controller - http://www.thingiverse.com/thing:516447\nThe knobs and air guides from the original design fit seamlessly into this remix:http://www.thingiverse.com/thing:523054http://www.thingiverse.com/thing:523003\nCheck the "Remix" section for more...\nThe display frame remains unchanged, while the case and lid/fan/display holder parts have been revised. A hinge has also been integrated to facilitate an open case design.\nClips are designed to clip the box onto a mendelmax frame with 70mm distance. Alternatively, you can secure the case using M3x10-12mm screws directly on the extrusions, spaced 50mm apart. The hole under the arduino mega pcb requires an M3x6-8mm screw without a spacer to prevent contact with the pcb.\nWhen using a 60x60x25mm fan, raise the mendelmax frame by approximately 30mm for clearance. A 60x60x10mm fan will require about 20mm between extrusions and your table.\nPlease note that this design was not created or tested by me. If you print it, consider uploading photos and providing feedback in the comments section.\nThe hinge currently requires support; I'm looking forward to finding a better solution...\nPost-Printing\nA few m3 screws and nuts are required: m3x20 and m3x16 for most assemblies. The lid needs one long screw, approximately m3x33mm.\nAfter printing, mount the case directly onto the frame or clips first. One of these screws may not be accessible if you install the arduino mega initially... an m3x20 screw with no nut on the underside should also fit.\nThe holes in the case are 2.8mm diameter and should provide a snug fit for a m3 screw.