Ramp Walkway for Legacy Millennium Falcon

thingiverse

This was designed without the original piece by taking measurements from the Falcon itself and using details based on photos I found online; as such all details may not be accurate. I used Ranki PLA filament in Light Grey for the ramp which is an imperfect but very acceptable color match, and SUNLU grey PETG for the tread. I'd recommend 0.2mm resolution for the ramp, 0.28mm for the prongs and tread is fine. I found printing the ramp standing up off the bed easiest to avoid massive supports, and separated out the prongs separately so their orientation would give greater strength while allowing the prongs some flexibility. Prongs and tread can be glued onto the ramp after printing. Original parts list for a premium on eBay so if this saved you some time and money I appreciate anything you want to kick over to me, or to the gracious authors of any of these other parts for the LMF: Cockpit canopy - https://www.thingiverse.com/thing:5214127 Escape pod cockpit canopy - https://www.thingiverse.com/thing:5214419 Escape pod hatch - https://www.thingiverse.com/thing:5214452 Interior double door - https://www.thingiverse.com/thing:5225228 Alternate interior double door - https://www.thingiverse.com/thing:5225235 Missiles - https://www.thingiverse.com/thing:3874152/files Landing gear; also radar dish (if scaled to 127%) - https://www.thingiverse.com/thing:4210117 Radar mount and support (if scaled to 127%) - https://www.thingiverse.com/thing:4848492 Cannon mount and gunner window - https://www.thingiverse.com/thing:2562355 Quad gun, trap doors, missile, landing gear (for purchase but cheap) - https://cults3d.com/en/3d-model/game/1-18-spare-parts-for-the-legacy-collectionn-millenium-falcon-bmf Sticker sheet - https://www.erikstormtrooper.com/bmf_stickers.jpg Sticker placement instructions - https://www.hasbro.com/common/instruct/87591.pdf