Ramp for Yamaha TRBX Bass Guitar

thingiverse

This is a custom ramp for my Yamaha TRBX605, but it should work on any TRBX600 and most likely TRXB500 series as well. I have not tested the latter, though. I print this design with support in place to create an even surface. Made in Tinkercad, here's the link: https://www.tinkercad.com/things/7fG1NoKblNA To make it stick, I used nano tape that's approximately 2mm thick. There's a corresponding 2mm cavity for some of that material. Use only as much as you need - about an inch square is more than enough. It's very sticky and hard to remove once the ramp is in place. I tested it on my TRBX, and I'm happy to report that it didn't cause any damage. However, keep in mind that I have the Matte Amber finish, so your mileage may vary. You might want to try it out on the back first just to be safe. Here's a link to the tape: https://www.amazon.com/gp/product/B07V38DCQD/ref=ppx_yo_dt_b_asin_image_o04_s00