RAM 2013-2017 Center Console Release Latch

thingiverse

My center console latch release snapped and upon close inspection, I discovered the original design had a critical flaw. To rectify this issue, I invested several hours designing and building a more robust one. Initially, I printed the new part without the rounded edges on the backside and used a power sander to adapt it to my needs. Later, I modified the design to incorporate this improvement. To ensure the plate properly attaches to the assembly, you may need to carefully remove some plastic from just above the holes on the right side (aligned with the vehicle's orientation). Be cautious when attaching the part to the rest of the assembly as it will be very challenging to disassemble without damaging something. It is recommended to print this part with extensive support and at an overhang angle of 55 degrees. A 50% infill percentage was sufficient for my prints. However, I recommend using ABS for any parts installed in your vehicle due to its durability. In this case, I used PLA and will replace the part if it fails again. Enjoy the benefits of this improved design!