RAK / Sparkfun LoRa Antenna Wall / Window Mount

prusaprinters

<p>This is a window or wall mount for the RAK and Sparkfun LoRa antennas, tested with the 90cm long 5.8dbi antennas that can be found here: <a href="https://www.sparkfun.com/products/15597">https://www.sparkfun.com/products/15597</a> <a href="https://store.rakwireless.com/products/fiber-glass-antenna?variant=39705894715590">https://store.rakwireless.com/products/fiber-glass-antenna?variant=39705894715590</a></p> <p>The design has both screw holes and space on the back to mount 3M Command strips depending on your preferred method of mounting. The hole in the bottom allows the N type connector to fit through while not allowing the antenna to pass. The screw holes will fit a 5mm screw shaft and up to a 9mm head size. This mount should also fit any antenna that has a similar base width of about 30mm diameter. If you have any other antennas that fit, let me know so I can add them into the description.</p> <p>For a smaller version of this mount that has been tested to work with the 45cm long Nebra antenna, visit this page: <a href="https://www.thingiverse.com/thing:4931849">https://www.thingiverse.com/thing:4931849</a></p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3 Pro</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.24mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>30%</p></div> <p><strong>Filament:</strong> eSun PETG Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>PETG or stronger recommended for extended use / for areas outside.</p></div> </p></p></p> Category: Electronics