Raise3d N2 Riser

thingiverse

I've been very pleased with my Raise3d N2, but it's time for a slight upgrade in the lid design to accommodate the bend in the filament tubes as they enter the extruder. I primarily use PLA, but due to its proximity to an AC duct, the N2 requires a custom-designed lid. I created these risers to attach securely to all four corners of the main enclosure and elevate the Plexiglas lid by approximately 30mm. Depending on your specific setup, you might need to adjust the height slightly as the filament tubes still make contact with the lid when it's fully extended. The riser features pre-drilled holes for easy installation of standard 4-40 machine screws to secure it tightly to the main enclosure.