Raise3D N2/N2+ Bed modification

thingiverse

This thing will be discussed in detail on the 3D Printing Today Podcast: nthreedprintingtoday.libsyn.com or search the iTunes music store or stitcher radio for "3D Printing Today". This thing is a modification of the Raise3D N2 and N2+ bed. The bed as delivered is a fixed position, factory leveled bed. Unfortunately, the folks at Raise3D did not take into account the probability of the bed going out of level, which it did for me. They also do not take into account when a user has a number of build plates and the plate height changes. Changing the distance between the hotend and the plate with the adjustment screw is tedious and painful. With this mod you can adjust it on the fly and get it just right without having to stop everything again and again. Additionally there were 2 major safety issues related to the bed which I address in this modification: Raising the bed off the lock screws which would eventually eat through the insulation fish paper Raise3D used which in turn would short out the bed. We are told by Raise3D that they only used these for the first batch of N2s that were delivered and that the path of the heater traces are no longer on these screws... and they changed the screws to nylon tipped. Insulating the edges and exposed solder points under the bed to protect against shorts which could easily be caused by using binder clips to hold the plate on to the bed. This condition is still apparent in machines being delivered. The modification includes: Replacing the 9 M3 bolts that currently hold the bed downward on to the lockscrews with 5 longer bolts. Insulating parts of the underside of the bed with Kapton tape. Adding lock nuts over PETG washers immediately under the bed. Adding compression springs. Adding PETG stabilizers which the springs sit on. Adding PETG wing nuts with an M3 locknut set into them. You will also need to move the limit switch bracket from under the Z shelf to above so that the limit switch thumbscrew can reach the limit switch. Adjusting: Plug the Printer in and let it boot. Go to the utilities menu and home the z axis then disable the motors(the icon in the upper left corner). Then move the extruder carriage manually to each position. When adjusted right, you want the entire motion distance between the bed and the bottom to be minimal. The trick to getting this right are the springs. These springs are the right size and strength to hold, in combination, about 40lbs without them compressing further. It has been argued that for the N2+ model with a print that could fill the entire 2 foot tall bed, these springs would compress and the object would then miss layers and ruin the print. If I were worried about printing that tall with that high a weight I'd either clamp the bed upwards so the springs would not compress or simply add four more springs without the bolts going through them using the four holes that are left unused from the previous approach. However, the springs I spec’d, The Midwest fastener #M159… I tested it with a digital scale. At mid compression each holds up 8lbs of pressure. 8x5=40… that’s 40lbs of pressure before the 5 springs are compressed further… that’s 18 spools of filament! My bed is still rock solid. No more too low in the front and too close in the back. I also can adjust bed height on the fly and not blind via the limit switch screw. There is zero x/y motion and I am finding the bed stays nice and level. I only need to check it when I remove/replace the plate. Thanks to the center bolt/spring I am able to adjust the bed to ensure there is no crowning effect as seen on 4 point leveling approaches on larger bed machines.