Raise 3D Door handle

thingiverse

This is a far superior door handle for the Raise 3D Printer. It fits all the models perfectly. Print Settings Printer: Raise 3D N1 Rafts: Absolutely Necessary Supports: A Must-Have Resolution: .1mm Precision Infill: 15% Density Notes: Print Poignee1 and Poignee2 at the same time if you have dual extruders. The result is truly impressive! It's highly recommended to rotate the part with the long way along the Y axis if your dual extruders are on the X axis, as this minimizes color smudging. Use a wipewall option if available. Post-Printing Print all the parts, then cut a diaper pin with 1/4 inch on one side and 3/8 inch on the other. Cut 1 1/4 inch of filament for the shaft. Put the diaper pin spring inside the handle with the long side pointing upwards. Put the base on top, push the filament shaft in. Ensure the shaft goes inside the diaper pin spring loop. Remove your printer door. Mark the door handle spot, and use a sandpaper to scratch the door surface. This helps the glue form a stronger bond. Glue the door handle base on the very edge of the door. I used cyanoacrylate glue, but any superglue will also get the job done. Re-install the door and enjoy!