
‘Rainproof’ Bird Feeder with three innovations.
thingiverse
Version 8. Inner core widened to improve fall of seed to the base. 45 degree slope added to the bottom of each opening to improve fall of seed to base. NOTE:- there is a seed funnel that screws on to the outside of the bottle thread, thus allowing a far greater volume of seed through a:- https://www.thingiverse.com/thing:4686550 Our garden birds flick the seed from side to side and spill half of it all over the ground where it starts to grow!. (They seem to be searching for the extra tasty bits). Also, when the seed gets wet, the birds get fussy and don’t eat it. This feeder has 3 innovative design features that help with these problems. 1. There is a low inner wall which stops the birds flicking the seed over the edge of the feeder. It catches the seed before it is flicked over the edge and remains within the outer walls. This saves wasting a lot of seed, . . . but annoys the pigeons who seem to prefer ground feeding. 2. The seed when it is delivered from the bottle does not fall to the base of the bird tray but is raised up 10mm so that it doesn’t rest in any water that may be on the floor of the feeder. 3. Rain tends to run down the sides of the bottle and into the feeder tray. The canopy which fits over the bottle neck deflects it to the outer area where it does less damage. The canopy also deflects rain that would otherwise fall into the inner ring. It is not necessary to print the canopy as the feeder will work adequately without it, albeit the seed getting wet.
With this file you will be able to print ‘Rainproof’ Bird Feeder with three innovations. with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on ‘Rainproof’ Bird Feeder with three innovations..