RAINBOW SIX SIEGE (SMOKE GRENADE - SMOKE GRANADE)

cults3d

English: Hello everyone, I bring you a model of the smoke grenade used by the attackers in the game Rainbow Six Siege. The body of the grenade is divided into 2 parts (Part1-1.stl and Part1-2.stl) to make printing easier. Part2 is the one for the grenade lock. Part3-1r is for the grenade hook. Piece4 will be printed 2 times to be the legs where the grenade hook will be attached. You should print all 5 pieces, then glue the pieces Piece1-1.STL and Piece 1-2.STL together to form the body of the grenade. Then you can join the rest of the pieces as you can see in the attached images and at the end paint everything, although I recommend to paint first and then join everything together. For the support of the legs (Part4.STL) that will be joined to Part3-1r.STL a small rod of 2.5mm diameter should be used. For the lock, a 2.5mm diameter and 80mm long wire should be cut and bent at one end as shown in the pictures. For the ring, you can use one from a key ring or from the same wire mentioned above, cut a piece about 240mm long to bend it as seen in the attached pictures. To make the safety (Part3-1r.STL) pop like a real grenade, you must get an 8mm diameter x 22mm long spring and a small screw to hold the spring. Here is the link to the video of the assembly on Youtube: https://www.youtube.com/watch?v=_bpI6D2UgEk I hope you enjoy it. Regards Español: Hello everyone, I bring you a model of the smoke grenade that attackers use in the Rainbow Six Siege game. The body of the grenade is divided into 2 parts (Part1-1.stl and Part1-2.stl) to make printing easier. Part2 is the one corresponding to the grenade insurance. Part3-1r is the one that corresponds to the hook of the grenade. Part4 will be printed 2 times to be the legs where the grenade hook will be hooked. The 5 pieces must be printed, then the pieces Piece1-1.STL and Piece1-2.STL will be glued to form the body of the grenade. Then they can join the rest of the pieces as seen in the attached images and at the end paint everything, although I recommend painting first and then joining everything. To support the legs (Part4.STL) that will be joined with Part3-1r.STL, a small rod with a diameter of 2.5mm should be used. For the insurance, you must cut a wire of 2.5mm diameter and 80mm long, which will be bent in an extreme as seen in the photos. For the ring, you can use one from a keychain or the same wire mentioned above, cut a piece of about 240mm long to bend it as seen in the attached images. For the safety (Part3-1r.STL) to pop like a real grenade, you must get a spring of 8mm diameter x 22mm long and a small screw to hold the spring. I leave my YouTube channel where I show the assembly https://www.youtube.com/watch?v=_bpI6D2UgEk I hope you enjoy it. Greetings