Rail Foregrip

thingiverse

I redesigned the foregrip so it's secured by two bolts instead of just one. I initially underestimated the strength of a single bolt, and the recoil might have caused it to crack under stress. By clamping it down in two places, the tension is more evenly spread out. Additionally, I hollowed out the center part slightly to minimize plastic usage. It's recommended to print this with PETG, ABS, Polycarbonate, or Nylon-X, which are my top choices. When slicing the model, make sure to rotate the foregrip 90 degrees so that the flat side faces down on the build plate. To prevent warping, it's a good idea to use a brim and an enclosure during printing, depending on the filament type used. Required hardware includes: * Two M3x30mm screws * Two M3 nuts