Radius Gauge Holder

thingiverse

This is a holder for inch radius gauge sets from 1/64 inch through 1/2 inch and the round gauge holding tool. Depending on the thickness of your gauge set and variations in printers, you may need to adjust the size of the slot to get a good fit so that it holds the gauges without them falling out if you turn it upside down while still being easy to insert and remove with minimal pressure. I have two versions: one with slots that are .028" thick for radius gauges from 1/64" through 1/4", and another version with .038" slots for the gauges from 9/32" through 1/2". I also offer a second version with reduced slot dimensions, specifically .025" and .035", designed for a tighter fit. These dimensions are referenced in the STL file titles. I printed on the long narrow edge to maintain a consistent slot gap using my Prusa i3 printer with PLA filament. Fumbling with plastic pouches has always been frustrating - they tend to fall apart quickly after use, which is why I created this holder.