Radiomaster TX16S Gimbal Spacer

thingiverse

Evening All. Not sure why my version of these files (https://www.thingiverse.com/make:834086) are no longer visable, so I have uploaded them again now. Thanks to the original designer for sharing the STEP files, as I wanted to make some slight alterations to the design. The main one being the removal of the raised ring, bringing the lower face up to the same height as the top of the ring. I did this to provide a completely flat face onto which the gimbal is bolted to, as I felt this was better to avoid distorting the gimbal should you over-tighten the 4 securing screws. As there was open air at each corner this would be easy to do, so making this spacer completely flat means I can tighten the corner screws without fear of distorting of the gimbal frame. I also opened up the holes slightly to allow more clearance on the TX case mouldings so I can remove them easier if required. For screws I used T2.6 X 12mm long, but some M2.2 X 12mm would also work. Ian Contessa