Radiant Tube for 2 Inch water hose

thingiverse

I am going to describe a basic water jet tube that produces a consistent, strong stream of water when attached to a 42 mm hose. This particular design requires no additional fasteners; instead, you simply wrap the hose tightly around the nozzle using wire or string to secure it in place. Additional files have been included with this submission, featuring alternative versions of the main component that can be connected directly to a screw head. The third part serves as a quick connector, eliminating the need for any additional clamping devices. To assemble this setup, start by cutting your hose using a sharp knife or scissors and then attach the quick connector to one end, followed by threading the hose over the main part. Finally, simply pull back on the quick connector, allowing its cone-shaped design to firmly clamp onto the hose's edge. This particular model was printed on an i3 Mega 3D printer, utilizing a Skirt around the bottom of the tube for added stability. Although it may be somewhat challenging to assemble these parts together due to their snug fit, some users have reported success by lightly sanding down any rough edges and then screwing everything together while the parts are still damp.