Radial Fan Fang E3D V6 40mm fan Remix

cults3d

https://youtu.be/b7YWOwUNp8g E3D V6: http://amzn.to/2wZBcBE UPDATE 08/24/17 I'm using the ABL stock mount from Timothy Hoogland. ABL Mount: https://www.timothyhoogland.com/download/creality-cr-10-ezabl-sensor-mount/?v=7516fd43adaa UPDATE 08/07/17 I finally got around to installing this model on my cr-10 and testing it out. What I found was that PETG works best of all. If you plan on reaching temperatures of 270-300 degrees, then I recommend adding a small strip of Aluminum Foil Tape (http://a.co/if9dAdt) to reflect some heat near the heater block, seen in the picture above. The fan used on the Fang is more powerful than stock and makes for a nice upgrade that helps with print quality. I used the stock 40mm fan to cool the E3D V6. I've got around 12 hours of print time with the E3D V6 so far, but I can say that print quality has gone up on the models I've printed. I combine the Fang's radial fan from jneilliii and the short E3D V6 40mm fan mount by lethala. I also cut down the Fang's tips by 5mm. This is for a Creality CR-10 but can be used with certain other printers as well. I'm using this model from Bandanam4n to mount the E3D to the printer: https://www.thingiverse.com/thing:2182924 Note: I have printed and tested if the components fit, checked the clearance of the nozzle, however, I haven't tested this model on an actual printer yet (still waiting for my cr-10 in the mail).