Radial Fan Fang E3D V6 40mm fan Remix

thingiverse

I am using the ABL stock mount from Timothy Hoogland at https://www.timothyhoogland.com/download/creality-cr-10-ezabl-sensor-mount/?v=7516fd43adaa I finally got around to installing this model on my CR-10 and testing it, and I found that PETG works the best. If you plan to reach temperatures of 270-300 degrees, then I recommend adding a small strip of Aluminum Foil Tape at http://a.co/if9dAdt to reflect some of the heat near the heater block, as seen in the above picture. The fan used on the fang is more powerful than stock and is a nice upgrade that helps with print quality. I use the stock 40mm fan to cool my E3D V6. I have about 12 hours of print time with the E3D V6 so far, but I can say that the quality has gone up on the models I have printed. I combine the radial fan fang from jneilliii and the short E3D V6 40mm fan mount by lethala. I also cut down the fang's tips by 5mm. This setup is for a Creality CR-10 but can be used with certain other printers as well. Note: I have printed this and tested if the components fit, and checked the clearance of the nozzle, however, I have not tested this model on an actual printer yet, still waiting for my CR-10 to arrive.