Rack Mount Adapter for Banana Pi M1 for modular 19" 2U system

prusaprinters

<p>Mount for the Banana Pi M1 with an additional 2,5" hard disk or SSD in a modular system 2u frame for 19" racks.</p> <p>USB and ethernet ports are accessible from the front via adapter cables. The front plate has built in button caps for the power and reset switches of the board.</p> <p>I used two USB panel mount adapter cables (15-20cm long) and a Delock 85124 panel mountable RJ45 female to female adapter and a short (10-15cm) ethernet patch cable to make the USB and ethernet ports available from the front.</p> <p>Four M3x6 or M3x8 screws are needed to attach the board mount and hdd/ssd mount to the front panel. The Banana Pi is mounted using M2,5x6 screws.</p> <p>In my case, the SATA cable sticks out a little over the top of the 19" rack mount frame. If this is an issue, an additional SATA 90° adapter might be needed.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Ultimaker</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ultimaker 2</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2 mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>50%</p></div> <p><strong>Filament:</strong> DasFilament PLA Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Use at least 50% infill for the hdd/ssd adapter. The other parts might work with lower infill too. I used 20% for the front plate.</p></div> </p></p></p> Category: DIY