Racing car seat phone stand with roll cage

thingiverse

EDIT: 21.2.2021 - Uploaded Mk2 version of 65° rails. 15.2.2021 - Added more "reclined" version of the rails for roll cage. You can decide which verion you want, both rail versions fit all sear versions and all roll cages. 23.10.2020 - Added seat with improved rear screw hole, so it should not bend rails if you tighten them. Also added seat with cable hole, but it won't work for my phone and I am not sure if it can be used at all. 4.10.2020 - Fixed slight angle on tubes behind head. Now it should bridge without support and without problems. Also added prototype rollcages by request. I would advise against using them, as they will be more difficult to print. 23.9.2020 - Added seat without cutout to be used as a decorative shelf toy. I wanted phone stand with car caring theme, but wasn't able to find exactly what I wanted, so designed one myself. My idea is to have phone stand or holder with modular design and customizable - I plan to add pen holder incorporated to the roll cage. Currently it is work in progress and just quick prototype done in one day. If you have ideas for improvement, or other attachements, feel free to share your ideas. Included are 2 versions - one with roll cage and one with only seat rails. Size is approx. 1/10 - you might use it in RC car also or with a bit of scaling. For assembly you will need M3 screws with coutnersund head. Ideal length is M3x10, but holes in the seat are through the shole seat, so you can use whatever you have on hand. For short verion you need 4 screw and for version with roll cage you need 8. Size of the completed stand is about 13cm heigth, 7,5cm width, 8cm length for short version and 13,5cm for roll cage version. Slot for phone is 1,5cm, should fit most phones with case without problem. Slot is also a little bit raised, so it will fit if you have magnetic plug on bottom. You will need about 45g of filament for short version and 65g for roll cage version.