Rachet wrench - fully 3D printable

thingiverse

This is my very first finished design using Solidworks, so I am actually pretty proud of it. I printed using supports and with 10% infill. I printed the lid on its side so that the two tabs were parrallel to the bed and would therefore be printed with smooth lines connecting directly to the body of the lid, rather than layers that would likely break off because they are so small.The gear with a socket pre-attached is a 3/8ths socket. And the gear with the pegs should be compatible with actual metal sockets (though I have not actual printed that piece to test that out yet)